Pin to face
Use pins to put one part of a picture on faces.
Pin to face fits one part of a photo to the faces. It can fit it to the whole sheet or to one face. Use it when sliding the picture around can’t line it up.
The flow
- Open the Photo card and select Pin to face to arm it. Corner and edge pins appear on the picture.
- Set the placement with the toggle. All faces (default) places the pinned part across the whole sheet. Single face places it on one face; tapping another face moves it there.
- Drag the corner pins to mark the part of the picture you want (e.g., a label on a jar). With All faces, four pins stand for the corners of the whole sheet. With Single face, there is one pin per corner of the face: three on a triangle, four on a four-cornered face.
- Drag the edge pins to bend the edges, for curved surfaces in the picture. Triangle faces have no edge pins.
- Select Stamp all faces or Stamp the face. The pinned part goes onto the faces, stretched from corner to corner.
The face’s outline is drawn on the picture between its pins. Each edge has the color of the corner it starts from, on the sheet and on the picture alike, so the colors match each face edge to its line on the picture. With All faces, every face’s outline is drawn over the picture, bent the way the stamp will bend it, with the sheet’s TOP and BOTTOM marks.
While you drag a pin, the faces in the 3D preview show the pinned picture. Nothing is stamped until you select a Stamp button, and the stamp matches the preview. A four-cornered face that isn’t a rectangle (a band of a ball, the side of a cylinder) shows the picture as one smooth stretch, with no fold along a diagonal.
The pins stay after stamping, so you can adjust and stamp again. Never mind removes the pins without stamping. Arming Pin to face turns off Cut away.
A picture not stamped yet is saved with the fig and comes back when you reopen Paint. Select ✕ on the Photo card to close it.
The pins are on the picture and each one moves on its own, so they can fix a picture taken at an angle. Pinning the corners of a poster shot at an angle places it flat and square on the face, like Warp it does for just that part.
Stamped parts turn into pixels at the canvas’s resolution, with the usual pixelation .
Three ways to place a photo
- Slide and stamp: Places the picture across many faces at once, by its position on the sheet.
- Pin to face: Fits the part of the picture you mark exactly to the faces you select.
- Warp it: Straightens the whole picture before you place it.
Walkthroughs that use this
No walkthroughs reference this tool yet.